Installation
Instructions for installing and powering your WATCHPAX 30.
General
- This equipment is for professional use for installation at locations where only adults are normally present. Check the "Safety First" list before use.
- The WATCHPAX 30 must be connected to a properly grounded wall socket (a socket-outlet with protective earth connection in the building).
- The serial number is located on the base of the unit.
Only use the power cord supplied with the WATCHPAX 30 unit, otherwise Dataton AB cannot guarantee full functionality.
Standalone Installation
Place the unit flat on its base. The base is the side of the unit showing the serial number and Dataton logo.
Power On
The unit is switched on by inserting the power cord or inserting the power cord and using the on/off switch. The discreet on/off switch is located behind the front plate of the WATCHPAX 30 (see Connectors in the Introduction).
Use a pencil or similar insulated tool to press the on/off switch. Do not use a metal implement.
First Power On
The first time you power up a WATCHPAX 30 (after delivery or after a reset) the system will finalize installation and reboot several times. This procedure will typically take about 5 minutes to complete.
Do not interrupt this procedure.
Power Off
Powering down should be initiated from within WATCHOUT production/Producer software or by using the on/off switch.
When the power-off sequence is complete, the fans will turn off, and the power cord may be removed.
If you need to perform a forced shutdown, unplug the power cord to turn off the unit.